 | Installation Guide |  |
|
| |
Update: 1999/08/30
STB Virge/GX
Target
To install the driver
Preparing for Installation
| |
System CD or System Restoration CD
The User's guide that came with your system
|
|
note
 | | You may have the floppy disk contained a driver.The driver in the floppy disk is the latest the driver.If you have same driver of the parts both Gateway System CD and the floppy disk, you must use the floppy disk. |
- Start up the system.
- Log in with Administrative rights.
- Click [Start], [Settinhs], then [Control Panel].
- Double-click [Display]. The [Display Properties] appears.
- Click the [Settings] tab to bring that page to the front.
- Click [Display Type]. The [Display Type] appears.
- Click [Change]. The [Change Display] appears.
- Click [Have Disk]. The [Install from Disk] appears.
- Click [Browse].
- Select the folder the Driver is contained, then press [Enter] key. The [Change Display] appears.
- Make sure [STB Systems, Inc. Nitro 3D (Virge/GX)] is highlighted, then click [OK]. The [Third Party Drivers] appears.
- Click [Yes]. The files copy, then [Installing Driver] appears stating the drivers have successfully installed.
- Click [OK]. The [Display Type] appears.
- Click [Close]. The [Display Properties] appears.
- Click [Close]. The [Display Properties] appears.
- Click [Yes] to restart your computer.
- After Windows NT restarts, [Invalid Display Settings] appears stating that a new graphics device has been installed. Click [OK].
- [Display Properties] appears.
- Click [OK] to keep existing settings, or use the Display Properties window controls to make any changes you want to the display.
CAUTION
 |
|
Please see User's guide for your additional references. This Installation Guide is made for the initial hardware configuration systems we ship. some processes would be changed depending on your hardware configuration.
|
|
Operationg System
