HelpSpot - Installation Guide

Top

SUPPORT@

Download Service

Technical Information

Installation Guide

Operating System

Operationg System

Desktop

Gateway PROFILE

Portable

SOLO 2500

SOLO 9100

SOLO 2150

SOLO 3150

SOLO 9300 (16.0x)

SOLO 9300 (16.8x)

SOLO 5300

Update: 1999/08/30

STB Virge/GX

Target

Windows NT 4.0

To install the driver
Preparing for Installation

System CD or System Restoration CD
The User's guide that came with your system

note

You may have the floppy disk contained a driver. The driver in the floppy disk is the latest the driver. If you have same driver of the parts both Gateway System CD and the floppy disk, you must use the floppy disk.

Start up the system.
Click [Start], [Settings], then [Control Panel].
Double-click [Display]. The [Display Properties] appears.
Click the [Settings] tab to bring that page to the front.
Click [Advanced Properties]. The [Advanced Display Properties] appears.
Click the [Adapter] tab to bring that page to the front.
Click [Change]. The [Update Device Driver Wizard] appears.
Click [Have Disk]. The [Install From Disk] appears.
Click [Browse].
Select the folder the Driver is contained, then Press [Enter] key. The [Change Display] appears.
[Change Display] appears. The [Select Device] appears again.
Highlight [STB Nitro 3D, with STB Vision 95] and then click [OK] to install the driver.
The installation program prompts you to reboot your system for the video drivers to take effect.
Reboot the system to enable the new video card.

CAUTION

Please see User's guide for your additional references. This Installation Guide is made for the initial hardware configuration systems we ship. some processes would be changed depending on your hardware configuration.